Layout the hose as on the brink of the form as you desire then fine tune it until it’s exactly correct. Using regular lawn lime and a Dixie cup , mark the hose location which are going to be one side of the new walk. Wash the hose and confirm you wash the lime from your hands. it’s great for lawns and eco-friendly.

 A handy tool you’ll use over and over is to chop a two by four, six inches longer than your walkway is wide. It are often used during layout to assure you’ve got prepared a good enough area for the pavers then as a screed board to level the bottom sand under the pavers themselves. Now, remove the soil, gravel, earth, etc. from the walkway area plus a minimum of three inches on all sides . you would like to excavate the walkway a minimum of two inches deeper than the thickness of the paver stones. If you would like the stones to be flush with the adjoining lawn or driveway, measure the stones thickness and add two inches and excavate thereto depth.
Once the excavation is completed, you’ll place a minimum of two inches of stone dust or concrete sand within the bottom of the excavation. Using your two by four screed board and a carpenters level, level the sand keeping it slightly above what you would like the finished product. Once the sand is in situ , a gasoline powered mechanical tamper must be wont to thoroughly compact the sand. confine mind that the sand will settle when compacted and extra material may need to be added across the walk to achieve the ultimate finished compacted height. you would like to be very fussy when doing this work. the ultimate walkway surface will reflect whatever defects you’ve got left behind within the way of dips or bumps within the sand. confirm the compacted sand/dust is a minimum of three inches wider on all sides than the finished walkway width.

Using a balkline to take care of the situation of 1 side of the walk is usually an honest idea. If one side is straight the opposite side will follow. Start laying your paver stones in whatever pattern you chose. line , lap bond, diagonal, herringbone or any pattern you’ll consider is ok . Work across the complete width of the walk and if you’ve got a helper employing a wet saw, cutting and placing any smaller pieces will greatly speed the work. 
https://alphapavingtexas.com/speed-bump-installation/