When installing this kind of equipment, the installation of the power system is an important task. When installing, you should first choose a suitable place to place the power system, and pay attention to laying down and fixing the motor. Then use the rope as the basis to drive the middle part of the pile firmly.

During installation, the two sections of bamboo poles should be connected with a rope first. When connecting each component, it should be noted that its tightness should be ensured so that the equipment can be used normally. The microporous tube cannot float in the water, otherwise it will affect the effect of use. Be careful not to tie it too tightly when fixing, and at the same time, make sure that the entire microporous tube is tied into a horizontal straight line.

The aquatic aerator tells that the same method can be used to install the remaining aeration pipes, but it should be noted that the installation of the microporous pipes in the entire pond mouth should be kept on the same plane. Installation of trachea. Since the bottom layer of each pond is different, we should pay attention to finding the reference point when we use the microporous tube. We have already told you about the use of microporous aerators. When installing, use a hose to connect with the aeration pipe. Note that the length of the rope should be slightly shorter than the pre-divided microporous tube.

So today we will introduce you to the installation of microporous aerators, mainly about aeration. Today, due to time constraints, we will introduce you to the installation of the microporous aeration and aeration equipment. When tying the rope, the place close to the main pipe should be lowered, or the place far away from the main pipe should be raised, so that the distance between the low end and the high end can meet the requirements of our use, so that the aeration pipe can be fixed to the rope., Ltd. It should also be noted that there should be two ends on the joint, one end is directly connected to the aeration pipe with a hose, and the other end needs to be connected away from the main pipe.

When piling, thick wooden stakes should be used, and thin bamboo poles can be used in the middle. The installation must be fixed and installed by professional installers. If your friends do not understand what we are talking about, please contact me for consultation, and we will arrange professional staff to provide you with services.. supplies aquatic aerators. A rope can be used to tie the two piles firmly, and a rope head is left at the pile for tying the microporous aeration pipe. We have already explained diesel aerator Manufacturers the relevant points for you. The spacing of each pile should be between three meters and four meters during installation