Moen's single-handle kitchen faucet set up utilizes a ball faucet, whereby metallic ball inside the faucet set up controls the flow and temperature from the faucet's water. The ball rests upon three rubber valve seats. The seats permit the ball to rotate using the faucet's handle. It's these valve seats in which the leaks from Moen's faucets are usually found. Replacing the seats is rather simple, and Moen produces repair kits. Not every Moen repair kits are identical, however, so make sure to note the type of the tap before going to the home improvement store.
Turn water supply pipes inside a clockwise direction to show water off. There's two valves beneath the sink. Both valves can be found in the heart of the 2 water lines. Each valve includes a single handle, which is often used to spread out or close the sink's water supply.
Take away the handle. Just one handle screw safeguards the handle to the top faucet set up. Tip back the handle to gain access to the screw, then take away the screw having a hex wrench and lift the handle from the set up.
Take away the cam nut and also the spout to gain access to the ball set up. The cam nut may be the metal cone which sits on the top from the faucet set up and underneath the faucet's handle. Twist the nut inside a counterclockwise direction with a set of adjustable pliers to get rid of it. Then lift the spout from the faucet set up.
Lift the circular plastic cam from the antique faucet set up, adopted through the metal ball. Then take away the valve seats and is derived. You will find three rubber valve seats at the end from the faucet set up. Pry each valve seat from the set up having a hex wrench. Observe that metallic spring slides onto the rear of each valve seat. Take away the springs with every valve seat.
Press each substitute valve spring onto its substitute valve seat. Then insert the seats into the foot of the tap set up. Lower the metal ball in to the faucet set up, adopted through the plastic cam.
Lower the faucet's spout within the set up, adopted through the cam nut. Tighten the cam nut using the adjustable pliers.
Put the faucet's handle onto the top cam nut, then install and tighten the handle's screw having a hex wrench. Turn each water valve inside a counterclockwise direction to revive water supply and also to complete the repair.
www.tapso.co.uk
www.tapforyou.co.uk
http://www.robinetshop.com
www.grifoso.com