1. The layout of the feeding hopper The feeding hopper is an inverted prism, and the feeding port is equipped with a wear-resistant ring, and the incoming material from the feeding equipment enters the crusher through the feeding hopper.
2. Distributor The distributor is installed in the upper part of the vortex crushing chamber. It is ejected at high speed, so that some other materials are bypassed from the outside of the middle feeding pipe into the outer side of the impeller in the vortex crushing cavity, and are impacted and crushed by the high-speed materials ejected from the impeller, without increasing power consumption and increasing production. Ability to improve crushing power.
3. The layout of the vortex crushing cavity The layout of the vortex crushing cavity is an annular space composed of upper and lower cylinders. The impeller rotates at a high speed in the vortex crushing cavity. The vortex crushing cavity can also contain materials to form a material lining. The crushing process of the material takes place in the vortex crushing cavity, and the crushing effect is separated by the vortex crushing cavity wall by the material lining, so that the crushing effect is limited to the material, which has the effect of wear-resistant and self-lining.
The investigation hole is to investigate the wear condition of the wear block at the launch port of the impeller channel and the wear condition of the liner on the top of the vortex crushing cavity, which is necessary when the crusher is working. The survey hole must be sealed tightly. The distributor is fixed on the upper cylindrical section of the vortex crushing cavity. The impeller rotates at high speed to generate air flow, and the internal self-circulation system is formed through the fire feeder and the impeller in the vortex crushing cavity.