Rubber Rings Factory introduces the preparation work before installing the sealing ring:

1. Before installation, all parts of the opened hydraulic system should be cleaned strictly, and special tools should be used to prevent fingers from being scratched by sharp metal edges.

2. Don't install it in the wrong direction and damage the lips. If there are too big scars on the lips, it may cause obvious oil leakage.

3. Do not install compulsorily, pay attention to the degree of fit, do not use a hammer, but use a special tool to first press the sealing ring into the seat hole, and then use a simple cylinder to protect the lip through the spline. Before installation, apply some lubricating oil to the lips.

4. To prevent overdue use, the rubber sealing ring should be replaced with a new one in time after the expiry date of the rubber sealing ring, and ensure the same size.

5. Avoid using old sealing rings. When using a new sealing ring, check its surface quality carefully to make sure that there are no defects such as small holes, protrusions, cracks and grooves, and it is sufficiently elastic before using it.

6. In order to prevent damage and cause oil leakage, it must be operated in accordance with the regulations, and at the same time, the machine must not be overloaded for a long time or run in a relatively harsh environment.


Through the above introduction, Pe Tubes Manufacturers hopes that you can simply refer to the content of this article in future use.