Plastic Crusher is a crushing equipment for plastic materials, as for the cause of slow down, first judge it It is related to the material itself, or the speed of the crusher should be slow, or the knife may be illustrative. If the knife is blunt, you can apply for a new knife or a new knife to the manufacturer. However, pay special attention to the edge grinding, the edge grinding must be carried out in the case where the blade can be sharpened, otherwise it can only be replaced. When using, corporate customers cannot discharge or discharge slowly. Remember not to knock the cyclone separator, just clean the air filter above the separator every day to ensure the ventilation of the filter. During the feeding process, if there is any deposit material, it should be stopped immediately.

After all accumulated materials are completed, it can continue to be consissed. However, we must pay attention to the quantity and speed of the feed, can't be too fast or too slow, sometimes too much or too little, we must feed the same amount as a unified speed, so that the plastic crusher can be used normally, production operations Ensure smoothly. Of course, there is no reason to feed slowly. During the injection molding process, poor products and nozzle materials, tits, gates, head materials, and axes. It can put into machine smashed edges in time.

After crushing, they separated by screening powder and keep pulverizing and drying. It is only 25 seconds to communicate and complete the recovery process. In the case of "two material proportional valves", the raw materials and nozzle debris are automatically mixed, injection molded, good products, and online recovery, there has been no waste. Our different models of machines smash different hardness materials are definitely different. We should also know the specific technical parameters and carefully check if they meet the technical scope. If the fault occurs, you can request a professional after-sales service person to check or call your consultation.

https://www.cn-lvdao.com/product/plastic-recycling-machine/